ProCoat solution

ProBond

High-adhesion coating for high-impact hard surfaces where ordinary paint scrapes off: laminates, doors, checkout stands, fitting rooms and retail fixtures.

Substrates

Laminates, restroom partitions, high-impact doors, checkout stands, fitting rooms, retail fixtures

Coverage

Varies by substrate

Colors

Any color

Application

Check the current data sheet for primer requirements, coverage and dry times on your substrate.

  • High adhesion
  • Any color
  • High-traffic surfaces
Where paint gives up

The coating for high-impact hard surfaces

ProBond is for high-impact hard surfaces rather than for ceilings. It is designed for the places where ordinary paint fails to hold up, and where a scratched, scraped or worn finish would otherwise mean replacement.

It gives a second life to surfaces that paint scrapes, scratches or peels off: laminates, restroom partitions, high-impact doors, checkout stands, fitting rooms and retail fixtures, all of them worn by high traffic and ordinary daily use. It is a specialty high-adhesion coating.

ProBond was specified across six hundred department stores, where the fixtures were rebranded in place rather than torn out and replaced.

A retail service counter coated with ProBond, finished to an even white without replacing the cabinetry
A retail service counter recoated where it stood. The cabinetry was not replaced.
Product data

Specification

Substrates Laminates, restroom partitions, high-impact doors, checkout stands, fitting rooms, retail fixtures
Color Any color
Application Airless spray, brush or roller, in place
Function Specialty high-adhesion coating
Recoat Yes

Fire performance, volatile organic compound content, dry times and coverage under specific site conditions are on the current technical data sheet. Confirm every figure against that sheet before writing a specification.

Turnkey, or product only

Turnkey

ProCoat surveys the ceiling, writes the specification and manages the project, and ProCoat’s own crews do the work as ProCoat Contract Services.

Product only

Buy the material direct from ProCoat or through a distributor, including Sherwin-Williams, and apply it with your own crew. Technical support is included, and the material carries a one-year product warranty.

Documents

Where it goes

What ProBond is specified for

Retail fixtures

Gondolas, end caps, display units and checkout stands, rebranded or refreshed in place rather than pulled out and replaced.

Restroom partitions

Partitions, doors and frames that are scratched or dated, where replacement means closing the restroom for days.

Fitting rooms

Fitting room walls, benches and doors, the surfaces where daily traffic shows first and shows worst.

High-impact doors

Doors and frames in back of house and service corridors, where ordinary paint scrapes off within a season.

Laminate surfaces

Worn or dated laminate given a new finish in place, without tearing it out and sending it to a landfill.

Over the existing finish

ProBond goes over conventional coatings without the lifting or wrinkling that solvent-based products cause, so a sound existing finish does not have to come off first.

Evidence

A service counter, recoated where it stood

Retail service counter with black and white panels before the ProBond coating
BeforeBlack and white panels, off the new brand palette
The same retail service counter after ProBond, coated to an even white without replacing the cabinetry
AfterOne finish, same counter

Nothing was taken out and replaced. ProBond is the one to reach for when the substrate is difficult and a standard coating would not hold.

ProBond on fixtures

Where this has been done before

ProBond goes on the surfaces that take the most handling, because those are the ones a decorative finish fails on first.

Find out what your ceiling needs

We can do a site survey to tell you whether the ProCoat solution is right for you. If replacement is truly the best solution, we will tell you that as well.

Let’s Talk