The coating for high-impact hard surfaces
ProBond is for high-impact hard surfaces rather than for ceilings. It is designed for the places where ordinary paint fails to hold up, and where a scratched, scraped or worn finish would otherwise mean replacement.
It gives a second life to surfaces that paint scrapes, scratches or peels off: laminates, restroom partitions, high-impact doors, checkout stands, fitting rooms and retail fixtures, all of them worn by high traffic and ordinary daily use. It is a specialty high-adhesion coating.
ProBond was specified across six hundred department stores, where the fixtures were rebranded in place rather than torn out and replaced.

Specification
| Substrates | Laminates, restroom partitions, high-impact doors, checkout stands, fitting rooms, retail fixtures |
|---|---|
| Color | Any color |
| Application | Airless spray, brush or roller, in place |
| Function | Specialty high-adhesion coating |
| Recoat | Yes |
Fire performance, volatile organic compound content, dry times and coverage under specific site conditions are on the current technical data sheet. Confirm every figure against that sheet before writing a specification.
Turnkey, or product only
Turnkey
ProCoat surveys the ceiling, writes the specification and manages the project, and ProCoat’s own crews do the work as ProCoat Contract Services.
Product only
Buy the material direct from ProCoat or through a distributor, including Sherwin-Williams, and apply it with your own crew. Technical support is included, and the material carries a one-year product warranty.
Documents
What ProBond is specified for
Retail fixtures
Gondolas, end caps, display units and checkout stands, rebranded or refreshed in place rather than pulled out and replaced.
Restroom partitions
Partitions, doors and frames that are scratched or dated, where replacement means closing the restroom for days.
Fitting rooms
Fitting room walls, benches and doors, the surfaces where daily traffic shows first and shows worst.
High-impact doors
Doors and frames in back of house and service corridors, where ordinary paint scrapes off within a season.
Laminate surfaces
Worn or dated laminate given a new finish in place, without tearing it out and sending it to a landfill.
Over the existing finish
ProBond goes over conventional coatings without the lifting or wrinkling that solvent-based products cause, so a sound existing finish does not have to come off first.
What it works alongside
A service counter, recoated where it stood


Nothing was taken out and replaced. ProBond is the one to reach for when the substrate is difficult and a standard coating would not hold.
Where this has been done before
ProBond goes on the surfaces that take the most handling, because those are the ones a decorative finish fails on first.
- Five nights on Michigan Avenue, and not one fixture replaced. A fashion flagship brought back to brand standards for about a third of the price of a full remodel, reported in Chain Store Age.
- Six hundred stores, rebranded without replacing the fixtures. The same approach run as a program across a whole retail chain.